Great MOD for adding front TURN and DAY RUNNING lights - 3D

[DiegoC]

Hello from Argentina my friends !!!
Today I will share with you my 3D printing work for adding DRL and Turn lights.

I started with these Acco covers only
I will use the clear lens as DRL and will modify the blackout lens for turning signal

https://www.oldwillysforum.com/forum/in ... pg.120779/

https://www.oldwillysforum.com/forum/in ... pg.120780/

Then you will need some dotted or triangle/piramid pattern acrylic

https://www.oldwillysforum.com/forum/in ... pg.120781/


https://www.oldwillysforum.com/forum/in ... pg.120782/

https://www.oldwillysforum.com/forum/in ... pg.120783/

https://www.oldwillysforum.com/forum/in ... pg.120784/

https://www.oldwillysforum.com/forum/in ... pg.120785/

https://www.oldwillysforum.com/forum/in ... pg.120786/

At this point you will need the 3D part that I designed with Fusion 360

https://www.oldwillysforum.com/forum/in ... ng.120787/

https://www.oldwillysforum.com/forum/in ... pg.120788/

https://www.oldwillysforum.com/forum/in ... pg.120789/

https://www.oldwillysforum.com/forum/in ... pg.120790/

https://www.oldwillysforum.com/forum/in ... pg.120791/

Now you will need some low profile lights
I used a 6 white-led board for DRL and an amber led light for the turn signal

https://www.oldwillysforum.com/forum/in ... pg.120792/

https://www.oldwillysforum.com/forum/in ... pg.120793/

Now the new screws
I needed shorter screws than the originals.... and I just used 2 long screws for holding

https://www.oldwillysforum.com/forum/in ... pg.120794/

Note that you will need to make some holes in the 3D part to bring the cables out.
I did not add the holes in the Fusion 3D design so that you can make them depending on the led lights/cables you use

https://www.oldwillysforum.com/forum/in ... pg.120795/

This is my jeep:

https://www.oldwillysforum.com/forum/in ... pg.120797/

This is where I will place the lights:

https://www.oldwillysforum.com/forum/in ... pg.120796/


I you are interested in this mod and want the 3D part I will be more than happy to share with you the .stl file
I only will ask $5 to support my work and continue to invest time in new 3D parts for our jeeps
Thanks for watching !!!

Diego.

You should read the directions for posting photos here in our Photo Posting Board and find a public link for each of your photos and insert that URL between a pair of these for for each photo. Might be easier to just load your photos to an album in our "Member's albums" page.

Wes K Admin