Page 2 of 2
Posted: Thu Jun 20, 2024 10:51 am
by RonD2
wesk wrote:Ron, My apologies for insulting your intelligence with my typo.
No worries Wes. I was neither insulted or offended.
I didn't realize the extent you manipulated the drawing.
It wasn't obvious it was your mistake.
Posted: Thu Jun 20, 2024 10:59 am
by RonD2
CapnDan wrote:I was wanting to add turn signals/flashers and the right stop light without cutting into my Vintage wiring harness. So, I am asking how best to do that, plug into existing harness with connectors or run new dedicated turn signal wires and stop light wires.
Danny,
I think maybe you answered your own question?
If you don't want to cut (or plug) into the existing harness --- the remaining solution is to run new wire.