Page 2 of 2
Posted: Mon Jan 02, 2012 12:39 pm
by heut
Thanks guys. I get it now. The distributor is installed correctly. Still have some items to complete before I can attempt to fire it up.
Any suggestions on batteries.? Also I was going to make my own cables. Can either of you provide any tips ?
Thanks again, you have been a big help!
Posted: Mon Jan 02, 2012 10:28 pm
by wesk
You need two 2HN batteries to be correct on the installation. The alternate would be the closest fitting civilian battery group 22NF.
Welding wire is the best out there on the market.
Posted: Tue Jan 03, 2012 7:59 pm
by heut
Thanks Wes. When you say " welding wire" is that a brand name or type? I am in Minnesota can you recommend where I can get it?
I appreciate all the help. Your distributor explanation was perfect. I did not look close enough to realize it was offset.
Cheers
Posted: Tue Jan 03, 2012 9:14 pm
by wesk
Welding wire from a welding equipment supplier. It is a little bit more expensive then regular battery cable but it is a whole lot better conductor.
Posted: Wed Jan 04, 2012 8:43 am
by RICKG
heut wrote:Any suggestions on batteries.?
51N R fits and is on the shelf at Wally World for about 75 bucks
a pop.