Page 2 of 2
Posted: Sat Mar 24, 2012 4:28 pm
by artificer
Why make this so difficult when it is not @ all. Call Moran glass in Brizzy & all over Qld & northern NSW. They will come to where your vehicle is cut the glass to suit the frame & fit same for you as part of the deal....If they stuff up they do it again, until right. They are not expensive!
Posted: Sat Mar 24, 2012 5:32 pm
by Phil4280
artificer wrote:Why make this so difficult when it is not @ all. Call Moran glass in Brizzy & all over Qld & northern NSW. They will come to where your vehicle is cut the glass to suit the frame & fit same for you as part of the deal....If they stuff up they do it again, until right. They are not expensive!
Hey thats great thanks. Will give them a call once I am back home . still down in Victoria after attending Corowa.
I was getting frustrated trying to deal with numerious glass mobs over the phone who were not interested if they cant pull it off the shelf.
Cheers!
Phil...
M38A1 GLASS MEASUREMENTS - I STAND CORRECTED
Posted: Sat Apr 28, 2012 10:51 am
by bluewatersailor
Today I used the WesK method of placing the gasket in the WS frame and measuring. I came up with 704 mm (27.71 in.) X 330 mm (12.99 in.). I cut two pieces of scrap plastic to those dimensions and radiused 2 corners at 3 in. They do fit but are, I think, a little tight. Therefore, I am going to give the glass man 702 X 327 which are virtually the dimensions you obtained in your 2 measurements. I stand corrected. My apologies for doubting. Keep up the good work.
Posted: Mon Apr 30, 2012 9:04 am
by 53a1
Better to be safe than sorry. Putting it is was a pain so let the glass guy do it if you can.