Page 3 of 3
Posted: Fri Jan 22, 2021 6:15 pm
by RonD2
Thanks Keith! That sure explains it and is very nice to know!
Posted: Fri Jan 22, 2021 10:47 pm
by wesk
There you go Ron. Drive the old one out and see if it lays flat and rolls even.
Keith, Do you have the associated Willys/Kaiser drawing?
Posted: Sat Jan 23, 2021 12:04 am
by WillysMotors
Yes, I have the Engineering Drawing.
I will try to find it and email it to you.
Posted: Sat Jan 23, 2021 12:52 am
by wesk
Thanks
Posted: Sat Feb 27, 2021 6:35 pm
by RonD2
Finally got around to punching the 3/4-inch drain hole in my tool box floor, along with a photo of the NOS rubber plug and the tool that I used to cut the hole.
