Page 1 of 1
Crankshaft Pulley Guard Spacers
Posted: Tue Sep 15, 2015 11:57 am
by Mjfire1949
1952 M38, 4-134 L, 24 volt, Serial # 65666, North Texas. Does anyone know where I can purchase the spacers that fit the crankshaft pulley shield bolts? I dropped the pan to install a new pan gasket, and found that the previous owner has used two 1/2 nuts on each bolt for a spacer. Thanks in advance.
Posted: Tue Sep 15, 2015 4:32 pm
by OKCM38CDN
Try Midwest Military... I got some from John a while ago....
Posted: Tue Sep 15, 2015 9:07 pm
by wesk
Or if you wish to fabricate from standard bushing stock:
Body Inside Diameter: 0.4665 inches minimum and 0.4685 inches maximum
Body Outside Diameter: 0.5615 inches minimum and 0.5635 inches maximum
Corner Shape: Square all corners
Material: Steel overall
Overall Length: 0.6865 inches minimum and 0.6885 inches maximum