Page 1 of 1
Seized Slave Receptacle
Posted: Wed Jul 06, 2016 9:39 am
by Hawkshadow
The cap on my slave receptacle is stubbornly seized in place. I've tried penetrating oil, moderate heat, and leverage while clamped in a vice to no avail. I know it's a long shot, but does anyone have any ideas?
Failing that, can I get the cables out of this receptacle to put in a new one without it open?
Thanks,
Posted: Wed Jul 06, 2016 11:55 am
by 4x4M38
Jordan,
Have you tried tightening just a hair?
Sometimes all it takes is for it to move, and it may only move initially to tighten. All you want is for it to budge. Then I'd do penetrating oil again, leave overnight, and try loosening. Rinse, and repeat.
Those metal to metal connectors depending on what they are made of can get a little corrosion that works as good as a decent solder job!
Good luck!
Posted: Wed Jul 06, 2016 8:10 pm
by wesk
You will need the front cap off if you have to remove the rubber insert. It comes out the front. Use the appropriate chapter of TM 9-1825E Bendix component manual. The manual is in our downloads sections in two parts. Chapter 4 for the early light switch and chapter 5 for the connectors.
http://www.willysmjeeps.com/v2/modules. ... it&lid=161
Posted: Thu Jul 07, 2016 2:09 am
by TGP
wesk wrote:You will need the front cap off if you have to remove the rubber insert. It comes out the front. Use the appropriate chapter of TM 9-1825E Bendix component manual. The manual is in our downloads sections in two parts. Chapter 4 for the early light switch and chapter 5 for the connectors.
http://www.willysmjeeps.com/v2/modules. ... it&lid=161
I downloaded Chapter four no problem as it's pdf format.
However chapter five requires drop box.
Don't do drop box so any way I can download and save?
Thanks
Tom
Posted: Thu Jul 07, 2016 8:42 am
by wesk
The drop box is a public file and is also PDF. It opens on line and then you click the top right little box with 3 dots and then click "Download".
Posted: Thu Jul 07, 2016 9:24 am
by TGP
wesk wrote:The drop box is a public file and is also PDF. It opens on line and then you click the top right little box with 3 dots and then click "Download".
Three dot box took me nowhere, but the download link worked after I got pass the pop up for logging in or registering.
Thanks for the help
Tom