Page 1 of 1
Bellhousing cable boot
Posted: Sun Oct 02, 2016 7:25 pm
by garcia63
I will be replacing the cable boot to the bellhousing and noticed that there is some thread marks on the inside of the hold where the cable goes into the fork. I looked at the illustrations and could not find a part that goes in there.
What part would go there? I am trying to link a photo.
Posted: Sun Oct 02, 2016 9:25 pm
by wesk
You can see the threaded nipple attached to the boot here:
This is the threaded nipple in the bell housing just above the circled stud.
You failed to indicate which model jeep you have.
If M38 ORD 9 SNL G-740 Page 50, lower view in Fig 02-2, Item X.
If M38A1 or M170 ORD 9 SNL G-758 Page 56, Item X.
Posted: Mon Oct 03, 2016 8:14 am
by garcia63
M38--thank you sir--Part Number 8328439 Clutch cable boot adapter would be the part I was looking for--already found it with a couple of vendors.