Page 1 of 1
Timing cover seal meeting oil pan seal
Posted: Fri Oct 07, 2016 9:37 am
by southpw
Just putting everything back together and wondered about a potential oil leak between timing cover and oil pan? Should I add some gasket maker in the corner where these 2 felt gaskets meet?
Brad
Posted: Fri Oct 07, 2016 9:51 am
by wesk
I would not use any RTV based gasket maker. I would use a bead of Permatex #1 at the juncture of the two gaskets before the covers go on.
Posted: Fri Oct 07, 2016 10:14 am
by southpw
Thanks Wes. i will need to pick some up before cover goes on.
Brad
