Page 1 of 1
Rear engine support
Posted: Tue Jan 24, 2017 1:08 pm
by 4x4M38
Is it possible to just replace the rubber on this jobbie
or do you have to replace the whole thing steel and all?
Posted: Tue Jan 24, 2017 10:47 pm
by wesk
It's a bonded assembly just like the side mounts are. I know of no outfit producing a stand-alone piece of rubber block replacement and even it someone did start producing a block of rubber that will fit the plates I see no way without ovens and special adhesive to re-bond the new rubber to the plates well enough to produce a strong long lasting assembly.
Posted: Wed Jan 25, 2017 12:50 pm
by 4x4M38
Thanks Wes.
It appeared to be a bonded assembly but much on this jeep appears to
be bonded until the application of solvents, heat, abrasives and torque
show otherwise.