Page 1 of 1
Cylinder Head Gasket - Urgent Request
Posted: Mon May 08, 2017 10:13 am
by whydahdvr
I need to get a part number for the cylinder head gasket. Is this part something I can get from NAPA or another local supplier or do I need to go through one of our MV vendors?
Urgent.
Thanks!
Posted: Mon May 08, 2017 11:13 am
by wesk
Posted: Mon May 08, 2017 1:52 pm
by cabinfever
This is where I got my copper gasket. I actually got in the mail overnight (it was sent Priority Mail). Of course, I live in the same state, so it might take longer to get to you.
http://store.midwestmilitary.com/product-p/807036.htm
Posted: Mon May 08, 2017 2:03 pm
by wesk
If you must locate one locally just request one for a 1953 CJ3A with L134 engine. or if their book doesn't go back that far then ask for a 1965 DJ3A with L134.
Posted: Mon May 08, 2017 2:03 pm
by cabinfever
I'm no expert, but several pros have recommended using the copper gasket like the one I posted the link for above.
If you want to get a Fel-Pro gasket, which is available at many auto parts stores, ask for Fel-Pro model #7543SBX.
Posted: Mon May 08, 2017 2:44 pm
by whydahdvr
Got it. Thanks!
Posted: Mon May 08, 2017 4:32 pm
by G740
If you go with the felpro or anything other than a copper gasket, you had better be prepared to re-torque the head at least 3 times.
John
Posted: Mon May 08, 2017 5:18 pm
by whydahdvr
What are the recommended valve settings? The valve clearances?
Looks like p 73 in TM 9-1804A has the valve clearance specs...