willysmjeeps.com

hi what i have here is a delco remy 24v 25amp regulator generator
the point is tht a friend of mine that have checked it said to me that this regulator doesnt have any burn but needs to be tested on the m38 and with some filers i must adjust it.....but how???? i mean is that easy? is here a european friend that maybe i should sent it and fix -adjust on his m38?

If it does need adjusting it is a fairly easy process. I outlined how I did it a while back- http://www.willysmjeeps.com/v2/modules. ... pic&t=9388.
Remember, do not remove the cover from the regulator while the batteries are hooked up!
Kendall

Use the proper technical publication and follow it precisely.
TM 9-8627 dated June 1953. will cover the Delco Remy regulator and the Delco generator. For the Delco generator you can also use TM 9-2920-214-35
http://www.willysmjeeps.com/v2/modules. ... it&lid=152

I don't have TM 9-8627 loaded on the downloads page but I do have the civilian Delco service instructions loaded there at:
http://willysmjeeps.com/downloads/Delco.reg.pdf

You can find additional info here: http://willysmjeeps.com/downloads/24%20 ... esting.pdf

Also I am sure Kendall meant to say "DO NOT REMOVE OR INSTALL THE REGULATOR COVER WHILE THE BATTERIES ARE CONNECTED TO THE REGULATOR"
24 Volt is a terrific fire starter when you make an accidental short circuit.

sorry but my knowlendges are not very good. is a european member that can help me by sending it to him

Try the M38A1 NEKAF web sites in Europe. If you do send the work to them be sure to send the regulator and the generator since they will need the actual generator you intend to mate to your regulator. If you only send your regulator you will have to finish the finer adjustments on your jeep.

Ok thanks i will have a try