willysmjeeps.com

I've committed the ultimate sin. I lost
an important part. I have no idea how
because the accompanying nut is still here.

So I've been to the usual places looking for
a suitable replacement washer for my front
transfer yoke nut.

The only thing with the correct 3/4" hole and
outer diameter that will fit in the yoke is no
better than grade 5. At best. I can't find
anything else like a grade 8.

The book says,
Washer, s, 3/4", sp

I'm assuming sp means special, and also
assuming tgat means it has a reduced total
diameter to fit in the yoke.

Will this work?

Tks,



[/u]

Find someone who rebuilds transmissions, transfer cases and differentials. They are readily available parts and they might even have one in the junk drawer.

There's a shop in town. I already hit them up
for poppet balls.

Is a loose fit on the shaft acceptable or does it need to be pretty
close? I'm thinking it would slip around a little until the nut snugged
it up while torquing.

The thickness is almost dead on, just concerned about the grade.

It's raining here, thank goodness, so I may go back for one more good
search. It's frustrating because I bagged and tagged everything, and
not only that but my wife will tell you I never throw anything away.

Hey Brian. If like me, the sooner I go buy another one is the sooner I'll find the lost one --- usually right where I left it, in the last place I look for it.

Got that right!