willysmjeeps.com

My M38a1 will not start.
No spark at spark plugs.

Removed distributor cover everything looks OK.
Points open/close when motor cranks and points not corroded.
Distributor contacts look OK.
Have 24 volts at entering wire at coil connection.
Have 24 volts at center connection of coil.
Have continuity from spring to center point of distributor.
Also have continuity from leaving coil wiring connection thru points.

Is there any way to check the coil and condenser?

Any other ideas of what may be wrong?

See Pages 82 and 83 of your TM9-8012.

If you don't have a copy they are free here to download
at the left above.

Take care,

In the manual it gives specs for the condenser, but not the coil.

It notes to test the coil, replace it with known good one to perform test.
That's a little pricey.

Anyone know what the coil primary & secondary specs are?

Look in my photo album under Ignition System

http://www.willysmjeeps.com/v2/modules. ... _album.php

Then click on Distributor

http://www.willysmjeeps.com/v2/modules. ... _album.php

You'll find the how to and the spec sheet there.

This info is great!

Thanks

The coil tested out to be bad.
Couldn't figure out exactly how to test microfarid's on the condenser.
So since condenser was fairly cheap, decided to replace it.

Out of curiosity, what do you use to read microfarid's ?

Thanks again.

https://www.youtube.com/watch?v=TFa6JfVu3B4

https://www.wikihow.com/Test-a-Capacitor