Howdy all,
I'm in the final stages of completing the vent lines on my '54 M38A1 and I've got a technical question. I see from ORD 9 SNL G-758, that the vac line that runs from the fuel pump to the crankcase vent T is 5/16" steel, but the vac line that runs to the T that leads to the wipers and the distributor is 1/4" steel. Just curious as to why the difference in the tube diameters. Thanks in advance for the tech education!
Bill S.
M38A1 Vent Line Tech Question
-
Madriver1968
- Contributor
- Posts: 61
- Joined: Sat Nov 26, 2016 6:00 pm
- Location: Rhode Island
-
wesk
- Site Administrator
- Posts: 16461
- Joined: Sun Apr 03, 2005 6:00 pm
- Location: Wisconsin
- Contact:
I would imagine that the flow requirements of the two branches were less then the total requirement at the "T".
Wes K
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Mjeeps photo album: http://www.willysmjeeps.com/v2/modules. ... _album.php
45 MB, 51 M38, 54 M37, 66 M101A1, 60 CJ5, 76 DJ5D, 47Bantam T3-C & 5? M100
Mjeeps photo album: http://www.willysmjeeps.com/v2/modules. ... _album.php