Spring bushing dimensions?
Posted: Mon Jun 18, 2018 5:24 am
Is there a NAPA number, or a set of dimensions for the silent block rubber spring bushings?
f
f
Page 1 of 1
Posted: Mon Jun 18, 2018 10:44 am
You are using a nomenclature that does not match any of the nomenclatures in the ORD 9. Please offer us a part number from the ord 9 or an ID photo of what you are looking for.
Posted: Mon Jun 18, 2018 5:09 pm
That is what we used to call the CJ leaf spring pivot bushings.They had a rubber sleeve inside.
Posted: Tue Jun 19, 2018 3:24 am
Rear end, part "Z"
Posted: Tue Jun 19, 2018 9:51 am
Ahh, The "Rubber Bushing" part threw me off but "Silent Block" does show up there. You want the Bearing, silent block.
This is the page with Z's part numbers.
If you will take the old Federal Stock Number (FSN) 3120-769-7597 and convert it to the later National (Nato) Stock Number by adding two 00's 3120-00-769-7597 then google that and you will get over
This is the page with Z's part numbers.
If you will take the old Federal Stock Number (FSN) 3120-769-7597 and convert it to the later National (Nato) Stock Number by adding two 00's 3120-00-769-7597 then google that and you will get over
. Then visit the first few sites and Voila!About 99 results (0.40 seconds)
And you will even find a few for sale there as well!Sleeve Bearing
SKU: 3120007697597 | Model: 7697597
Specifications from the Manufacturer
Overall Length: 1.9900 inches minimum and 2.0100 inches maximum Body Outside Diameter: 0.7800 inches minimum and 0.7850 inches maximum Body Inside Diameter: 0.4470 inches minimum and 0.4530 inches maximum Flange Outside Diameter: 0.8780 inches minimum and 0.8830 inches maximum Flange Width: 1.7400 inches minimum and 1.7600 inches maximum End To Flange Distance: 0.0940 inches minimum and 0.1560 inches maximum Corner Shape: Square inside right corner Corner Shape: Square right flange outside left corner Left End Body Diameter: Any acceptable Right End Body Diameter: Any acceptable Material: Rubber intermediate layer Material: Steel outside diameter surface of flange Style Designator: 21c solid, external flange Style Designator: Solid, external flange
Posted: Thu Jun 21, 2018 4:44 am
I did not know that about the Nato Stock Numbers
What else does it work with?
f
What else does it work with?
f
Posted: Thu Jun 21, 2018 11:10 am
What else does what work with?What else does it work with?
Posted: Sat Jun 23, 2018 3:02 am
never mind
Posted: Sat Jun 23, 2018 9:27 am
You mentioned a NAPA # at the beginning. I forgot to address that. The reason there's no NAPA listing for the CJ's is because they use a greasable 9/16-18 bolt without the metal/rubber bushing/bearing and the M38 uses a non-greasable 7/16-20 bolt with the silent metal/rubber bushing/bearing.
This is the CJ2A, 3A bolt:
This is the CJ2A, 3A bolt: