willysmjeeps.com

Hi all

I need some close up pictures of the throttle linkage system
The Jeep is a CJ3B/M606 so from a M38A1 will be perfect

(And if someone know the size of the nuts and bolts at the Chocke assy.)

from the Carb (YS950S) to the pedal

I have the CD for M38(A1) GPW/MD but the pictures are a bit too dark.

Best Regards

Niclas

Niclas,
You should be able to find the photos you need on my photos site:
http://wsknettl.mypicgallery.com/
Then you can positively ID the parts you can't find in the manual and post those needs here.

And as always you have an answer

Thx Wes

I found out what I needed

but 1 thing I dont understand

the bolt/screw i need are Part no 131958 (ORD9 SNL G758 group 0301)

No:8-32NC-2 x 5/16

No:8 = size
32 = lenght
NC = UNC
but 2 x 5/16 I have no clue what that is.

Im used to the Metric system.


/Niclas

You don't see that -2 much anymore and I'm not positive of it's meaning but I believe it identifies a category or class of hardware. The 5/16" (inch) is the overall length. The 8 is the diameter, the 32 is the thread pitch and the letters NC represent National Coarse (thread group)