Page 1 of 1
Technique for camshaft gear removal
Posted: Fri Dec 22, 2006 3:47 pm
by Kendall
I am attempting to remove the camshaft gear from L-134, M38 engine. Been reading TM 9-1804A, but without the special puller I am having trouble getting other gear pullers to work. Any suggestions? Also, where are the timing marks on the gears that are mentioned in the Note on the bottom of page 47 in same manual? Thanks for your help, Kendall
Posted: Fri Dec 22, 2006 7:22 pm
by wesk
Any attempt at prying against it's rim will result in a broken gear. Get the correct puller or buy a new gear.
Timing marks are very small dots. The crank gear dot is at the bottom of a space between two teeth and the camshaft gear dot is right on the front of one tooth.
Posted: Sun Dec 24, 2006 5:27 pm
by gorzel
Where can you get the correct puller?
Posted: Sun Dec 24, 2006 6:27 pm
by wesk
Snap-On, OTC, Proto, Northern Tool and etc,
A push / pull type puller kit that comes with both bolts and flange legs ''
Posted: Sun Dec 24, 2006 11:43 pm
by gorzel
OK. Just a regular puller. Not a Jaw puller. Good I have it already.
Thanks