willysmjeeps.com

I make vent lines for the M-38 and the M-38A1.

I only make the lines, they come complete with the Tube nuts on the ends and any loom as called for in the SNL.

I can make them from Copper, Steel or NiCopper (Nickel Copper – More expensive due to material, but look correct for factory restoral).

I just need to know what lines you need and the material they are to be made of. The only line I recommend to be copper is the 86” vent from the fuel tanks to the air filter as there are lots of bends as you install it and it is easier to install.

ALL Lines are coiled and packaged to be shipped, I do not bend to fit, this saves on shipping and handling. As long as you are careful install is straight forward.

Send me and email to kb1zq@swbell.net and we can work out the details of what you need or want.

I can also do Brake and fuel Lines, Please note I will not do the little "S" lines in the front axle brake lines; I can make them but NOT bend them...

Drop me a line...

Hal,
What's your going rate these days for the vent lines?
Thanks.
Josh

I do not have a set price as most folks want a mix of lines and I go from there... average cost is roughly $5.00 per line for Copper and Steel. NiCopp price goes up as that material is more expensive, looks great but not cheap...

Hal,
Do you have a source for the S clips that hold the manifold to vacuum pump and the vacuum pump to wiper T tubing on the M38?

Someone else found these and I have ordered some... they appear to be correct...

https://www.inlinetube.com/products/CLP108

Those referenced by Hal.


Ryan's M38 Guide

Thanks Hal and Wes. I will see about ordering some, they appear the substantially same to me.
Ralph