willysmjeeps.com

Hi all,

I'm working on my carb and I'm installing a new low speed jet tube. The prior tube was easy to remove. I unscrewed the bleeder tube assembly with a 1/4 inch wrench, and just pulled out the low speed jet tube with my fingers.

I'd love advice on how to install the new one. Does it get pushed into place in any special way? How far into the hole?

Thanks!

B.

Here's a good place to start:
http://www.willysmjeeps.com/v2/modules. ... pic&t=7634

Your jeep's ORD 9 has a very good illustration and parts listing.

You should have already downloaded our TM 9-1826A dated 1952 for Carter Carb Servicing and overhaul.
http://www.willysmjeeps.com/v2/modules. ... it&lid=142

Thanks Wes! You are truly a found of knowledge, and very kind with your time!