Page 1 of 1
Clarification on Valve adjustment please!
Posted: Mon Apr 04, 2022 12:35 pm
by arisLgr
On the TM1804A I read on page 86 paragraph 80 that 0.016 clearance should be set on all valves, but further down under Servicability Standards on page 126 it gives for the Intake 'Valve to tappet clearance 0.116' and on page 127for the Exhaust valve it gives 'Valve cap to tappet clearance 0.016'
Please clarify this for me!
Aris
Posted: Mon Apr 04, 2022 1:48 pm
by arisLgr
ok, got my English and inches right, it shoyld be 0.016 inch for all valves.....
Posted: Mon Apr 04, 2022 5:03 pm
by jake138
.406mm if that helps
Posted: Mon Apr 04, 2022 8:34 pm
by wesk
Aris,
You said:
but further down under Servicability Standards on page 126 it gives for the Intake 'Valve to tappet clearance 0.116' and on page 127for the Exhaust valve it gives 'Valve cap to tappet clearance 0.016'
The 0.116 entry on page 126 is a Minimum clearance(NOT MAX) and is applied to only the intake stems. The entry 0.016 on page 127 is the MAX clearance between Exh valve rotator cap and tappet. Yes these entries can be confusing.
Posted: Tue Apr 05, 2022 1:15 am
by arisLgr
Yes, it did sound 'Greek to me' Thanks guys!