Page 1 of 1
M38A1 Windshield Dimensions
Posted: Thu Feb 08, 2007 7:29 pm
by davistroy
I need to make a pattern for the glass shop to make windshields for my M38A1 - does anyone have the length and height of the glass (I can figure out the radii)?
Windshield M38A1
Posted: Mon Feb 19, 2007 10:33 pm
by USMCM38A1
Any luck yet I haven't gotten out to the barn yet too much snow here in Ohio but I have a template I will measure it for you if you don't have it yet.
Posted: Tue Feb 20, 2007 12:18 am
by wesk
The parts lists says to use a piece of 1/4" thick safety plate 16" x 50". The best bet is to take your windshield off and take it to the glass shop.
Posted: Wed Feb 21, 2007 3:53 am
by davistroy
I finally found a place that will make the glass(es) from the frame and gasket - it is a placee that handles old car restorations. Most places I called only handled stock glass installation, not any cutting.
FYI - it is Farmer's auto glass in Mableton, GA.