Page 1 of 1
Posted: Fri Nov 11, 2022 12:53 pm
by pickle
Hi good discussion. I am looking for dimensions for the clamp strap that holds tank to the back floor on M38. Look for width and thickness of material
Posted: Fri Nov 11, 2022 1:22 pm
by RonD2
Hi Pickle,
Mine is 1-inch wide and looks to be 11 gauge thick (.120", a little less than 1/8-inch).
I didn't unbolt it to measure thickness.
Here's a good photo of one:
https://www.ebay.com/itm/302427409600?h ... R9b49ICNYQ
This is a 7 year old post.
It's true that a lot of posts drift off topic all over the place, but it's usually better to start a new post when you have a new question.
Usually gets more visibility, and less muddy water in the old post.
Good luck!
Posted: Sat Nov 12, 2022 12:22 am
by pickle
Thanks ron. Really appreciate that.
One more quick question. What is length between bends?
Posted: Sat Nov 12, 2022 1:37 pm
by RonD2
Hi Pickle,
Yeah, I was wondering why you didn't ask for that dimension.
So I unbolted mine to measure.
No easy way to get a dimension due to the radius of the bends, so I measured outside to outside --- from the bottom edge of the flat bolted to the floor to the top edge of the hook.
Overall, it's 1-15/16 inches tall.
I'm pretty sure the tang on the tank that the bracket mates to is made to be bent up or down slightly for adjustment to get a good clamping fit.
Good luck!