willysmjeeps.com

I am gathering the guages for my M-38 CDN, so far I have an original Fuel gauge and Oil pressure (120 psi) guage... The SNL lists a resistor that goes with these guages. In the SNL; Figure 06-12 it shows the Fuel, Oil and Temp gauges with what looks like and "L" shaped unit on the back of them. Do I need to find these or will all work with out...

I need to find a Temp guage (PN - 7389567) and all will be original, save the voltmeter due to a solid state regulator...

Comments, please...

Hal,

On the manual photos, they show the early style temp gauge with the external resistor.

The later style gauges had an internal.

I know you already found some gauges, but thought I would post this in case someone else had a similar question.

Ryan,

This is an older post, I have all the gauges, my temp does not work, bad gauge? but all is well at this time...

Hal,

Have you checked out the 24V gauge troobleshooting guide on the download section under electrical?

I have a set of gauges that I am going to send out for repair.

There is a place called Bob's Speedometer.

Ben Daugherty had them do some work and he was very pleased.