Page 1 of 1
Accellarator pedal adjustment.
Posted: Thu Mar 15, 2007 7:40 am
by Ryan
My M38 does not go to full throttle when my foot pedal is pressed all the way down. I was thinking that I could add some washers in between the throttle lever on the block and the throttle pedal and that should give me the extra throttle I need. Anybody else have any suggestions?
Posted: Thu Mar 15, 2007 8:27 am
by maeserik
i put washers between the leverplate and the block, about 0.16 inch - 4 mm. This sets the ac.pedal a little higher, which is easyer to drive
I had the same problem, maybe the tube is not exactly on the frame, a little bit backwards?
at full trottle the pedal just do not touch the floor
Erik
Posted: Thu Mar 15, 2007 4:46 pm
by OKCM38CDN
The rod from the carb to the accelerator pedal should be threaded to allow for adjustments... I have about 4 inches of thread on the rod on my M-38...
Hope this helps...
Posted: Mon Mar 19, 2007 2:04 am
by maeserik
after put washers between the leverplate and the block i adjusted all with the thread on the rod so the acc. pedal was in the highest possible position