Page 1 of 1
What size srew hold on the dash plate?
Posted: Sun Apr 15, 2007 1:38 pm
by Bill_F
Title says what I need. I need to get a vin verification done so I can get the m38 registared. What size srews hold the dash plate on?
Posted: Mon Apr 16, 2007 11:07 am
by usma41
In Florida we use the number that is on the engine block.
Posted: Mon Apr 16, 2007 1:56 pm
by Bill_F
I have the vin number, i just need to bolt it back to the dash, then have either a state trooper or inspection station say yes that is the number for the jeep.
Posted: Mon Apr 16, 2007 3:51 pm
by wesk
Hello Bill,
You could make it easier if you positively ID'd weather you are (A) trying to fasten a serial plate to the dash directly on a MC before serial 34151 or (B) are you trying to fasten a serial plate to the large mounting plate used on vehicles after serial 34151 or (C) are you trying to fasten the large mounting plate to the dash of a vehicle after serial 34151?
A=[Ord # 128273, FSN 5305-012-8273] Screw tapping pan hd gimlet-pt, sht mtl-thd, S, cd or zn pltd, No. 6 (0.138) x 3/8" superseded by [Ord # 161790 FSN 5305-016-1790] Screw tapping thread forming, cross-reces-pan-hd, gimlet-pt, sht-mtl-thd, S, cd or zn pltd, No. 6 (0.138) x 3/8".
B=[ ORD# 109953 FSN 5320--010-9953] Rivet, tubular, oval-hd, br, 1/8 x 1/8
C=[Ord # 128273, FSN 5305-012-8273] Screw tapping pan hd gimlet-pt, sht mtl-thd, S, cd or zn pltd, No. 6 (0.138) x 3/8" superseded by [Ord # 161790 FSN 5305-016-1790] Screw tapping thread forming, cross-reces-pan-hd, gimlet-pt, sht-mtl-thd, S, cd or zn pltd, No. 6 (0.138) x 3/8".
Posted: Mon Apr 16, 2007 3:57 pm
by Bill_F
Wes,
I am trying to fasten the large plate to my dash, the plate that has all the date plate riveted to it.
Posted: Mon Apr 16, 2007 6:14 pm
by wesk
Then what you need is listed under "C".