Bumper hole dimensions needed

GregS · Post by **GregS** » Mon May 16, 2005 10:29 am

I need to reach out to you fine folks to help me out. I have a repro. bumper on my M38 and it is missing a few of the original holes. Could someone please measure their original bumper and provide me with "A", "B" and the distance between the two green lines. Also, the size of the holes. I quickly put together the picture so if you need clarification please let me know.

Thank you so very much.
Greg

Post by **Ryan_Miller** » Mon May 16, 2005 3:14 pm

Greg,

I have a paper tracing I made from an original bumper for hole placing and sizes. This is much more accurate than trying to measure and drill holes.

Email me your address (I may still have it) and I will mail it to you when I get back from my brother's.

I owe you for the fording valve!

GregS · Post by **GregS** » Tue May 17, 2005 7:19 am

Ryan,

Thanks!

You have repaid me many times over, I owe you at this point. Your (along with many other folks) work has certainly furthered the hobby.

Greg