Page 1 of 1
double pulley water pump
Posted: Thu Jul 12, 2007 3:53 pm
by keats
I have a double pulley water pump I plan to install on my M38. I don't remember where I got it but probably at a show somewhere. I noticed that the replacement does not have the bearing retainer clip nor a slot in the housing for the clip that my old one has. New design? What holds the bearing in place on these pumps?
Posted: Thu Jul 12, 2007 8:13 pm
by Cacti_Ken
I took one like that apart a couple of years ago. If I recall right they are pressed in.
Posted: Fri Jul 13, 2007 9:38 am
by timrod
i will buy your old one you take off??
Posted: Fri Jul 13, 2007 7:22 pm
by keats
Sorry I plan to get a rebuild kit for it myself. That was why I asked the original question as I was also wondering if there are two different rebuild kits available for the pumps in queation.