Page 1 of 1
M38 fording cable install?
Posted: Sat Sep 08, 2007 5:51 pm
by TonyMorreale
Installing my NOS fording cable today ('52 M38). Does the longer of the two cables go to the pcv valve or the oil fill tube/cross tube? It looks as if it can go either way and will have to be cut/shortened no matter what...
Posted: Sun Sep 09, 2007 4:42 pm
by OKCM38CDN
Tony,
Becarefull when shortening the cables, use a hacksaw and carefully cut the outer sheath to fit then cut the center cable... I ruined on by cutting to quickly and incorrectly...
As for location it does not matter, they cut to fit... More than likely the vendor sent you one from an M-37 as thy are all the same...
Hope this helps...
Posted: Sun Sep 09, 2007 5:45 pm
by TonyMorreale
Thanks - I used a dremel to cut the outer sheath. Got the PCV side working great. Oil fill tube - not so much. Valve closes but will not open when I push the handle back in - the inner cable bows and the valve remains open. I can't lengthen the outer sheath to stop the bow now that it's cut and there's no room to lengthen it anyway because if I do the valve will not open because it will hit the sheath.
I didn't really plan on using it much anyway and will probably keep the valves wired open as a precaution (I had an issue where the valve at the PCV wiggled closed and created quite an oily mess).