Page 1 of 1
M38 Starter
Posted: Wed Jan 09, 2008 11:41 pm
by ambec
Hey, guys, Need some help. What is the correct ord # for the early M38 starter? I am converting over to 24 volt on my rebuild and the starter I have is too large to fit into the bell housing. The number on it shows for a 38A1. Any help would be appreciated or a source to buy the correct one. Thanks..Eric
Posted: Thu Jan 10, 2008 8:27 pm
by Jeeps4Brains
Eric,
This is from the manual. Wes please correct if wrong.
Early is G740-7762616 this is the one in the picture in my manual and matches the one I have for my M38.
The other one is G740-8328132 for engines after 74419. I think that was when the bell housing was changed.
Alan
Posted: Thu Jan 10, 2008 9:09 pm
by ambec
Ahh, Great, thank you, Alan, appreciate the replyand the info...Eric
Posted: Fri Jan 11, 2008 7:38 pm
by ambec
Okay, I have been checking around and have not found one so far, of the flat end. Anybody got one they want to get rid of, money wise or trade? If not, I guess I can use my 12 volt, got off my underhood battery to a push starter like the WWII ones and go from there..Thanks...Eric
Posted: Fri Jan 11, 2008 10:36 pm
by wesk
Hello Eric,
The early m38 starter Prestolite/Auto-Lite MBP4301UT (flat nose, small frame 24V mounts with 3/8" bolts) is still available. John at Midwest Military has rebuilds in stock. The later M38 starter MCZ4001UT is the closed nose 24V and uses 1/2" mount bolts. It is the same starter used on the M38A1 and the M170. It too is readily available.
Be sure to copy the instructions for set-up of the new starter in your jeep.
Posted: Sat Jan 12, 2008 9:30 am
by ambec
Hi, Wes,
Thanks for the info, however I talked with John yesterday and he no longer has the flat end. Gave me a couple of leads, especially Brent Mullins, but won't be able to try before Tue. Will let you know what I find out. Thanks again..Eric
Posted: Fri Jan 18, 2008 11:15 am
by ambec
Brent had one in stock, so that does that for me..Thanks for the help, Eric
Posted: Tue Jan 22, 2008 9:09 am
by US-M38
ambec wrote:Hi, Wes,
Thanks for the info, however I talked with John yesterday and he no longer has the flat end. Gave me a couple of leads, especially Brent Mullins, but won't be able to try before Tue. Will let you know what I find out. Thanks again..Eric
You may also want to check with Peter Debella Jeep parts or Surplus City Jeep parts. Both require a core exchange, but worth looking into.