Page 1 of 1
How to remove round rubber xfer mount from x-member?
Posted: Fri Feb 08, 2008 10:09 pm
by tdavis
I am trying to figure out the best way to remove the round rubber mount from the transmission cross member ... ideas? Help!
Posted: Sat Feb 09, 2008 8:57 am
by OKCM38CDN
Wet it down with a spray lub and hit it with a brass hammer a couple of times...
rubber mount
Posted: Sat Feb 09, 2008 5:57 pm
by hillbilly21
could use a torch and heat it up a little to soften it ..should pop right out
Cup in a cup
Posted: Mon Feb 11, 2008 10:46 am
by rdsar2k
My 1955 M170 with the same drive train has a metal cup containing the rubber supprt that is installed in another metal cup on the cross member. Extremely rusted in. I used a chisel on the lip of the metal cup containing the rubber support. Make sure you hit the cup containing the support and not hit the crossmember cup. The new rubber support has a new metal cup as an assy. Sounds like we are at the same stage in overhaul. I just painted my front axle this weekend and I am going to wrap it up next weekend. Waiting on sandblasting of the tub and frame so I'm also working on axles and drive train parts.