Page 1 of 1
M38 Engine groud strap
Posted: Sun Feb 10, 2008 1:58 pm
by jcastig
Hello everybody
How long and how width is the ground strap that goes between the engine front plate and the motor mount on the M38
Thanks in advance
Jorge Castiglioni
Montevideo, URUGUAY
M38
M100
Posted: Tue Feb 12, 2008 9:04 am
by maeserik
mine is 5 inch, you can see it on the enginepic.
http://www.willysmjeeps.com/v2/modules. ... _photo.php
Erik
Posted: Tue Feb 12, 2008 2:05 pm
by jcastig
Erik, Thank you very much (Merci beaucoup)
Jorge
Posted: Thu Feb 14, 2008 3:49 pm
by Cacti_Ken
You should consider that the ground cable should be of the adaquate gauge. Because the current that is going thru the starter and engine block and back to the frame ground can have an good a path for the high current passing thru it. Other wise the starter might not perform as it should. I believe I am correct in saying this. If not somebody correct me.
Posted: Thu Feb 14, 2008 10:47 pm
by wesk
You are correct. The ground strap must be equal to or larger than the sum of the cables feeding +24 volts to it. Generally that would be the combined loads for the starter, ignition and generator field.
Posted: Fri Feb 15, 2008 1:04 am
by maeserik
Be aware you have clean and bare metal between all the ground connections, otherwise you can have problems, even with a 24 volt system where the cranking current is less critical in compare with a 6 or 12 volt setup.
Erik