Page 1 of 1
Transfer case/output shaft bushing on M38
Posted: Sat Mar 15, 2008 8:52 pm
by bucky
I am rebuilding my transfercase, tranny done already. The output shaft in the transfercase contains a bushing worn out long ago..... How on earth do you get the old bushing out to put the new one in?.....Its probably simple thats why I cant figure it out. Thanks bucky
Posted: Tue Mar 18, 2008 12:38 pm
by Ryan_Miller
I am trying to remember what that looked like, but it seems to me that you need to use a hydrolic press to put them in and sometimes to take out the bushings.
Anyone else on this. It has been a few years since I did this part.
If you look in the military maintinance manual it goes through the process of tearing down and rebuild.
Posted: Wed Mar 19, 2008 11:46 am
by tdavis
I think you need to take it to a machine shop - I think it is a press fit. The new bushing will need to be reamed to fit your output clutch shaft.
Posted: Wed Mar 19, 2008 1:13 pm
by wesk
If you are referring to the pilot bushing item # 54 you need a blind hole bushing puller.
Posted: Wed Mar 19, 2008 10:11 pm
by bucky
Thanks Guys, my local machine shop changed it for me.Tranfer and tranny are back in. I took it out for a run this morning, much better speed. Now for the rear axle......... Bucky