Page 1 of 1
Top Bow Measurements...
Posted: Sat Mar 22, 2008 8:58 am
by OKCM38CDN
I know this has come up before, did a search and could not find it...
I have a set of reproduction top bows, they do not come with the holes drilled in them for the rods to the windshield... I need the measurements from the pivot point to the holes...
Thanks...
Posted: Sat Mar 22, 2008 12:32 pm
by tdavis
Posted: Sat Mar 22, 2008 4:57 pm
by OKCM38CDN
This covers all but the measurement I need...
The measurement to the holes for the brackets to the winshield was not covered in this discussion...
Posted: Sat Mar 22, 2008 6:38 pm
by tdavis
This part wasn't what you needed?:
Dwg 2:
A - 32.5
B - 39.5
I added the following:
C - 3 (Inside radius of bend in bow tubing at top of bows - same on both)
D - 25.75 (End of bow to ctr of hole for top bow rod on outboard side of short bow)
E - 0.375 (Top bow rod hole diameter)
Posted: Sat Mar 22, 2008 8:47 pm
by OKCM38CDN
Sorry, did not see that... was looking at the photos for what measurements were taken...
Posted: Sat Mar 22, 2008 10:00 pm
by tdavis
No prob - let me know if you need any other measurements not on that post and I will run out to the garage and measure for you.