Page 1 of 1
bell housing
Posted: Thu Dec 04, 2008 9:05 pm
by johnsfind53
Me again, the knowledge freak. I'm wondering if one of you guys could tell me the size of the hole at the bell housing, where the bell meets the transmission.
Thanks in advance
John
Posted: Sat Dec 06, 2008 8:57 am
by Ryan_Miller
John,
Are you talking about the overall width of the bell?
Just clarifying, I was not sure.
Posted: Sun Dec 07, 2008 3:08 pm
by johnsfind53
where the input bearing retainer fits through the bell housing. example would be a gm truck bell has a five and one quarter inch hole.
Posted: Sun Dec 07, 2008 6:17 pm
by wesk
4.25"