Timing Mark
Posted: Thu Jan 22, 2009 7:31 am
I am missing the 5 degre before TDC mark pointer on my L head. Any pictures of what it should look like. I am almost in time!
Scott
Scott
Page 1 of 1
Posted: Thu Jan 22, 2009 8:02 am
A quick search of this web site will yield the answer to a question asked at least every 3 or 4 months. Do you have the TDC mark? If so the 5 BTDC mark is 5 degrees of crank pulley travel before the TDC mark. Or about the width of your pinky.
Posted: Thu Jan 22, 2009 8:44 am
Wes,
I think I have the TDC mark, but it might where the tab was attached?
I was looking for a picture to compare. I tried to search and got nothing.
Scott
I think I have the TDC mark, but it might where the tab was attached?
I was looking for a picture to compare. I tried to search and got nothing.
Scott
Posted: Thu Jan 22, 2009 11:55 pm
Scott,
I just ran the search function here using "timing marks" as the key words and got 86 hits back.
http://www.willysmjeeps.com/v2/modules. ... de=results
Here's a couple of the 86 hits:
http://www.willysmjeeps.com/v2/modules. ... ming+marks
http://www.willysmjeeps.com/v2/modules. ... ming+marks
Here are a few examples of timing marks out there:
I just ran the search function here using "timing marks" as the key words and got 86 hits back.
http://www.willysmjeeps.com/v2/modules. ... de=results
Here's a couple of the 86 hits:
http://www.willysmjeeps.com/v2/modules. ... ming+marks
http://www.willysmjeeps.com/v2/modules. ... ming+marks
Here are a few examples of timing marks out there:
Posted: Fri Jan 23, 2009 6:43 am
Wes,
I was searching articles. Thanks again
Scott
I was searching articles. Thanks again
Scott
Posted: Fri Jan 23, 2009 9:24 am
It's best not to use the thread titles for searches since on all forums the thread title is very often related to only a very small percentage of the items discussed in that thread.