Page 1 of 1
m38 alignment
Posted: Sat Apr 11, 2009 10:35 am
by Bill_F
Ok next weekend I will be installing a bunch of new steering parts in my m38. What is a quick and diry way of getting the alignment close?
Posted: Sun Apr 12, 2009 2:40 am
by wesk
The quick and dirty can't be determined until we know which parts are being replaced. The only information not very clear in the manual is the tie rod installations and how to initially set the lengths. Easiest is to measure distances from centers first then change the parts and set new rods to same length.
The only steering alignmnt function you can perform is the toe-in/out checks and they are very clearly explained in the manuals as well.
Posted: Sun Apr 12, 2009 5:10 am
by Bill_F
The bell crank is being rebuilt, along with all the tie rods being replaced. I was looking through the manuals I have and could not find the specs.
Posted: Sun Apr 12, 2009 11:52 am
by Ryan_Miller
I thought it was in the TM 8012 toward the back.
Posted: Sun Apr 12, 2009 4:50 pm
by Bill_F
Thanks, I found it now.
Posted: Sun Apr 12, 2009 10:19 pm
by wesk
The problem with TM 9-8012 and TM 9-804 and TM 9-1804B are they scatter the procedure too much. You have to hunt and peck for it. The civvy manual SM1002 is a lot easier to follow.
Posted: Mon Apr 13, 2009 4:34 am
by Bill_F
I will have to see if I can dig up my civvy manual.