snubber bummer

MODIFIED · Post by **MODIFIED** » Wed May 27, 2009 5:09 pm

has anyone a pic/diagram that successively displays the stack order of the snubber (Transfer case support) installed upon the center cross-member ? For a 1955 M38A1/M170 cross-member; is the actual metal dish / seat the rubber "donut" lies welded on to the member..or bolt in place ? thank you

Post by **wesk** » Wed May 27, 2009 6:33 pm

Bowl is welded to the crossmember, then donut then large flat washer, then transfer case then lock washer then nut.