Page 1 of 1
Gear shift knob for M38
Posted: Sat Sep 26, 2009 11:19 pm
by GeorgeMcKenzie
I bought a knob for the gear shifter leaver for my M38 CDN . The leaver is about 3/8 " in diamiter . and the hole in the knob is about 1/8 " .This is a push on one so do I have to make the hole bigger or can it be forced on the leaver .This is the only M38 in my area so I could use some advice on this Thanks for any help George
Posted: Sun Sep 27, 2009 8:03 am
by Ryan_Miller
George,
Push it on, give it H%**!
Gear shift knob
Posted: Sun Sep 27, 2009 9:28 pm
by GeorgeMcKenzie
Thanks for the info .George
Posted: Tue Sep 29, 2009 8:46 pm
by DJ
A little off topic, does anybody else besides me have screw on knobs? Would be curious to se how many of each are out there.
DJ
Posted: Fri Oct 02, 2009 7:00 pm
by Cacti_Ken
mine are screw on.
Posted: Fri Oct 02, 2009 9:21 pm
by DJ
Both my M38's have screw on.
DJ
Knobs
Posted: Sat Oct 03, 2009 3:44 pm
by skyjeep50
My M38 has screw on knobs and my M38A1 has push on knobs. I did replace the knob on my A1 and the replacement knobs hole was a very small diameter - cram it on and it will hold tight. If you enlargen the hole it will be a loose fit and the knob could come off.
That's the hole knobby story!
