Page 1 of 1
Transmission Cover Plates
Posted: Sun Oct 04, 2009 8:40 am
by Jeeps4Brains
I was trying to find some posts on what to put down between the transmission covers and the floor.
I think originally they used some kind of black rope type caulk?
Should I not use anything since I am not going fording?
What are some suggestions?
Alan
Posted: Sun Oct 04, 2009 8:52 pm
by OKCM38CDN
If you have an ACE hardware store near you, go to the insulation weatherproof section and look for what they call Rope Caulk Weatherstrip. It comes in a 2 1/2" x 2 1/2" box and is a gray caulk. ACE part number 52515, there is 30 feet in the roll, in 4 seams that run side by side...
Tear off one seam apply to the floor and tighten down...
Nearest thing to original I can find, maybe was original who knows... This is what I found on mine when I took it apart...
SEAL, strip type, 3/16 in diam bead x 80 ft lg (used
w/PLATES, G740-7395158, G740-7697523, and G740-
7697526 and COVERS, G740-7697422, and G740-
7697578)
Hope this helps...
Posted: Mon Oct 05, 2009 1:45 pm
by Jeeps4Brains
After I put this stuff on how easy is it to pull up the cover to do work?
Can I just bolt the cover back on after working or is it a mess?
Posted: Mon Oct 05, 2009 1:58 pm
by wesk
You just pry it loose with a screw driver and some of the bead stays on the floor and some will stick to the panel but it is still in the form of a flattened bead and poses no significant problems.