Page 1 of 1
M38 head studs
Posted: Fri Nov 20, 2009 9:22 pm
by 52M38
I need to know if the head studs on my RMCXXXXX are all suppose to be the same length and if not which ones are longer and also the location of the long ones. Thanks. Brett[/b]
Posted: Fri Nov 20, 2009 11:30 pm
by wesk
Brett,
Look at page 39 of your ORD 9 SNL G758 M38A1 parts manual!
The M38A1 uses bolts for the head not studs.
Posted: Fri Nov 20, 2009 11:45 pm
by 52M38
These are for an M 38 not M38A1. RMCXXXXX. Thanks.
Posted: Sat Nov 21, 2009 1:15 am
by wesk
Getting late. The data is also in the M38 ORD 9 SNL G-740 page 27 12 short and 3 long. And the step by step is in the TM 9-1804A page 94 & 95.
Posted: Sat Nov 21, 2009 9:02 am
by 52M38
As always thank you Wes.
Posted: Mon Nov 23, 2009 7:23 am
by maeserik
Thanks, so the bolts on my M38 enginehead are original, i wondered why there where bolts used and not studs with nuts as in our GPW. In the past before i restored my M38 the engine had been rebuild ( greek rebuilding tag on the block ) and the head was fixed with bolts. Because compression was good and equal on all cylinders i left the head on the block.
Erik
Posted: Mon Nov 23, 2009 10:53 am
by wesk
M38A1 F134 engine head uses bolts.
M38 L134 engine head uses studs.