Page 1 of 1
Floor Drain Parts
Posted: Sat Dec 05, 2009 10:02 pm
by dod03-52
Anybody out there have a good picture of the pieces and parts for the floor drain assy. The ORD 9 book is not much help.
Posted: Sat Dec 05, 2009 10:47 pm
by wesk
These have the rubber gaskets glued to them. I believe the early ones did not have the rubber gasket.
Floor drain parts
Posted: Sun Dec 06, 2009 6:11 am
by dod03-52
Thanks Wes, what does the wingnut screw into? I have nothing attached to the floor for the threads to go into.
Wing nuts
Posted: Sun Dec 06, 2009 7:25 am
by G740
The wing nuts in the photo are not correct.
They go into a weld nut attached to the floor in the center of the two larger holes the covers go over.
John
Posted: Sun Dec 06, 2009 11:53 am
by wesk
John, Does your replacement floor panels have the weld nut installed?
Floor pans
Posted: Mon Dec 07, 2009 6:28 pm
by G740
Our floors have all weld nuts and associated hardware in place where needed before we ship.
John
Posted: Mon Dec 07, 2009 9:37 pm
by wesk
Glad to hear that. Do you have an illustartion of a correct thumb screw?
Posted: Sat Dec 19, 2009 8:33 am
by Cacti_Ken
Wes did you ever get a reply on the question of the correct thumb screw?
Posted: Sat Dec 19, 2009 1:40 pm
by wesk
No, John must be on Christmas break!
Posted: Sat Dec 19, 2009 11:36 pm
by DJ
Page 11 on his web site under M38 parts is a picture of them.
DJ