Page 1 of 1
Dimensions for M38 Data plate backing plate?
Posted: Sun Feb 14, 2010 10:18 am
by avmechanic
I am building a M38 jeep and need to make a steel backing plate for my reproduction Data plate set. I need the Dimensions for the backing plate that the data plates are attached to. I could also use a good picture of the layout of all the plates including the winch data plate so I can fabricate what I need. Thanks.
Greg
Posted: Sun Feb 14, 2010 11:51 am
by wesk
The late M38 and the M38A1 and the M170 all use the same mounting plate.
The plate is 10 7/8" wide by 7 1/4" high.
The four mounting holes for the plate are all 1/4" in from the side edges and 9/16" from the top and bottom of the plate.
The four corners are rounded at about a 3/8" radius.
The 3 left data plates left edges are 1/2" from the left edge of the mounting plate.
The 3 right data plate right edges are 1/2" in from the right edge of the mounting plate.
The data plates start 1/16" down from the top and end 1/16" up from the bottom. With equal vertical spacing.
Posted: Sun Feb 14, 2010 2:51 pm
by avmechanic
That is great. Just what I needed. I will get to work and make a plate up. Thanks.
Greg
Posted: Mon Feb 15, 2010 2:12 am
by wesk
Master plate
Posted: Tue Feb 16, 2010 6:44 am
by G740
You know, for $17 you can buy a new one from me.
John
Midwest Military
