willysmjeeps.com

Hi Guys,
I am looking for the dimension from the bottom of the cowl to the top of the step.
The previous owner had welded the steps back on after they had rusted off with a lot of bronze. I would like to get the new steps that I fabricated as close to the original location as possible.

Also I suspect that the front corner of the step should line up with the bottom edge of the fender mounting flange. Correct me if I am wrong please.

Thanks
Pat

The measure is 14 & 11/16 inches the fender dropes abuot 1/4 inch below the step where the two bolt togather.

Thank you.

I just didn't want to weld the step on and have to cut it off to move it after
the floors and had channel's were installed.
With no floor and no hat channel's to reference to I was second guessing
myself.
I am not saying I have done a "bone head" move like this before, however If you ask my friends they will tell you I have quick enough!

Thanks again
Pat