Page 1 of 1
Sector shaft
Posted: Fri Apr 22, 2011 10:48 am
by Bretto
Is the sector shaft diameter measurement taken on the shaft itself or at the splines. (if there is a difference) I dont have it with my right now but had my wife measure it at home and the shaft measured at 15/16". I dont want to order the wrong part. The ORD 9 shows 2 different parts for differnent serial # ranges.
Thanks
Posted: Fri Apr 22, 2011 2:35 pm
by MODIFIED
for an M38A1
-O.D. of the shaft itself should be 15/16" (0.937")
-span of pins are 2" on center
Posted: Fri Apr 22, 2011 7:52 pm
by wesk
Yes there are two different size pins based on the diameter of the smooth surface that rides in the bushings,
Posted: Fri Nov 04, 2011 9:46 am
by brachus12
Did you find a replacement? All the other posts on here seem to say that M38A1/M170 sector shafts are no longer available.
Posted: Fri Nov 04, 2011 10:14 am
by Bretto
Ya, it's been a while but I got it at Kaiser Willys. Its a 15/16" shaft.
http://www.kaiserwillys.com/product/812 ... ccessories
Posted: Fri Nov 04, 2011 10:57 am
by brachus12
I saw that, but right under that part, they have this:
Asked by Mariano Rodriguez, December 19, 2010 at 09:13:12 PM EST.
Q: Will the15/16 sector fit the 1955 m38a1
1 Answer
Answered by Willys Tech, December 24, 2010 at 12:12:17 PM EST.
A: No, this is for M38 only. I do have the ball bearings and bushing for the M38A1 however.
Posted: Fri Nov 04, 2011 11:02 am
by Bretto
I have a M38
Posted: Fri Nov 04, 2011 11:13 am
by Bretto
M38a1 part 807478. I cant find any but only looked for a minute. Might just want to call John at MWM
found this also.
http://www.4wheelers.com/jeep-sector-sh ... -3196.html