Page 1 of 1
transfer case crossmember
Posted: Sun Sep 18, 2011 6:51 pm
by circleburner12
cleaning the crossmember on the m38a1 and notice the rubber mount was too bad to reuse. got it out and notice a cup was welded to the crossmember and appeared to be another cup that the mount set in.
?- does anyone have a illustrated breakdown or picture of this crosmember? thanks for any info
Posted: Sun Sep 18, 2011 10:39 pm
by Oldsalt
All of the crossmembers have that transfer case mount and the mount kit is readily available on the MV parts websites. Here is a link to one on Walcks.
http://walcks4wd.com/transfer-case-moun ... -d-18.html
Posted: Mon Sep 19, 2011 1:43 pm
by circleburner12
thanks oldsalt, im taking it that the cup that is spot welded to the crossmember stays on and some how i need too get the other cup that had the rubber mount in it, out of the welded cup?
done of the manuals i have show the breakdown of the crossmember, so thanks for all the info.
Posted: Mon Sep 19, 2011 1:48 pm
by RICKG
Circleburner, i've got a used trans mount set if you're
interested i'll get pics..
Posted: Mon Sep 19, 2011 5:55 pm
by circleburner12
after cleaning the rust and parts of the rubber mount out of the cup i seen how it was. it reminded me of a race for a bearing, with some wd40 and a hammer it came out. thanks for the info guys.