Headlamp gasket

Bretto · Post by **Bretto** » Sat Jan 07, 2012 7:38 am

Does anyone know of substitute or if anyone carries the gasket material for part B 7375024. I can't say what I have is stock or not. Mine almost looks like weatherstripping but it has a lip that went over the front edge of ring C. The one pictured almost looks like its just flat.

[/img]

RickC · Post by **RickC** » Sat Jan 07, 2012 7:49 am

While we're asking about headlight gaskets...anyone have a source for the one that goes between the bucket assembly and the grill???
Rick C

Bretto · Post by **Bretto** » Sat Jan 07, 2012 8:45 am

Rick
Saw someone selling a set on fleabay 'buy it now' this morning for about $16 shipped.

DJ · Post by DJ » Sat Jan 07, 2012 10:40 am

Midwest Military, page 12 of th M38 parts.

evanso1975 · Post by **evanso1975** » Sat Jan 07, 2012 11:14 am

Mine almost looks like weatherstripping but it has a lip that went over the front edge of ring C. The one pictured almost looks like its just flat.

Mine have the lip too, with what seems to be a wire ring inside the rubber. The overspray of Strata Blue suggest that these could be original. Of course, they're too far gone to be reused.

This vendor is advertising them for the princely sum of $9.95 each:

http://www.surplusjeep.com/M38/M38_%20Lead_%20Page.htm

Owen.

Post by **wesk** » Sat Jan 07, 2012 11:25 am

The last time I bought the sealing ring for the door and the gasket for the bucket they were a lot cheaper than $9.00 from Pete Debella.

Also everything in that illustration is common to all the M series trucks up through the 10 tons. So don't limit your shopping to only jeep parts dealers.

circleburner12 · Post by **circleburner12** » Sat Jan 28, 2012 4:20 pm

does part (b) gasket go with part (a) or part (c)? and how is it position on either part?

i think it goes on part a with the wire clips holding it in place, but i cant figure out the correct way it goes on. could anyone post a detailed pic of this gasket and how it's mounted?

any help would be much appriciated. thxs

Bretto · Post by **Bretto** » Sat Jan 28, 2012 8:17 pm

The gasket B clips to part A (door) then C (ring) goes thru both

circleburner12 · Post by **circleburner12** » Sun Jan 29, 2012 3:47 pm

that's what i was thinking brett, but the gasket with the wire in it. is what im having alittle trouble figuring which way it lays into the headlight door. so the clips will hold it in place. thxs