Page 1 of 1
hood block holes
Posted: Thu Jun 14, 2012 7:35 pm
by Bretto
Can someone get me a measurement of mounting holes center-center of the holes in the hood for the blocks? I bought some hood blocks and the holes aren't lining up, too far apart. And they are junk. Just want to make sure my hood holes are what they should be.
Thanks,
Brett
Posted: Thu Jun 14, 2012 8:17 pm
by RCFlyguy
I don't have my hood with me, but my wood blocks (original I believe) measure 2.6 inches on the dot, center to center.
Posted: Fri Jun 15, 2012 7:30 am
by RICKG
As measured from my orig junk hood..
12-15/16 hole C/L from hood center seam.
2-1/4 1st hole C/L from leading hood edge.
2-5/8 C/L spacing between holes.
Posted: Fri Jun 15, 2012 11:03 pm
by Bretto
Thanks guys, thats what mine measures also. Now I have deal with getting these back to the vendor. Almost not worth the $11 I spent on them. They look like MD Juan flavor. I don't know if they make hood blocks but they have that crappy red primer on them
Posted: Sat Jun 16, 2012 6:25 am
by oilleaker1
So, are going stepped or square?
John
Posted: Sat Jun 16, 2012 8:00 am
by wesk