Page 1 of 1
Extra part on axle
Posted: Tue Oct 16, 2012 7:04 pm
by donthedickens
A friend bought a jeep frame and installed a body he built. He thinks the frame was from a CJ5. The frame has this piece attached to the front axle passenger side going toward the rear of the frame.
http://s577.beta.photobucket.com/user/D ... ave%20jeep
Does anyone know what it is for?
Thanks,
Don
Southeast, NC
53 CJ3B
Posted: Tue Oct 16, 2012 10:02 pm
by wesk
Don,
I have a late CJ5 front axle I bought a while back and put in my 60 CJ5. It had the same arm. I believe it's a anti-spring-wrap-up device. Keeps the spring wrap-up to a minimum under high axle torque loadings.
Posted: Wed Oct 17, 2012 6:27 pm
by donthedickens
Thanks for the replies. It turns out it is a travel stop (not proper term) to protect either the oil filter or maybe the oil pan on some vehicles with the V-6 installed.
I even got a couple of pictures from Marty that made it very clear. I posted it in the file with my first two pictures.
http://s577.beta.photobucket.com/user/D ... ave%20jeep
Anyway, I have my answer. THANKS ALL !!!!
Don
Southeast, NC
53 CJ3B
Posted: Thu Oct 18, 2012 10:01 pm
by wesk
Don,
It is in fact a torque reaction control device. It limits spring wrapup resulting from hard braking on Jeepsters with the Dauntless V6. I looked it up in the Jeepster service manual. Chapter M.
https://f86bf0c4-a-62cb3a1a-s-sites.goo ... edirects=0
Posted: Fri Oct 19, 2012 6:32 pm
by donthedickens
Thanks for the additional information Wes. I took it to Dave this morning and he is a happy guy and says thanks. He started to cut the bar on the axle off, but now will keep it and import the chassis stop plate from the old frame to the new one.
Thank you for the extra effort and the education.
Posted: Fri Oct 19, 2012 8:13 pm
by wesk
Perhaps he can get us some detailed close-up photos of the bracket when it's off the old frame with some measurements? I would be interested in adding that bracket to my CJ5 frame.
Posted: Sat Oct 20, 2012 5:43 am
by donthedickens
I will work on getting pictures and other details for you.
Posted: Sat Oct 27, 2012 3:06 pm
by donthedickens
wesk wrote:Perhaps he can get us some detailed close-up photos of the bracket when it's off the old frame with some measurements? I would be interested in adding that bracket to my CJ5 frame.
Wes,
I lost my chance to get pictures and measurements. The frame went to the recycle yard with the bracket attached.
Posted: Sat Oct 27, 2012 7:55 pm
by wesk
No worries Don. I went out to my storage area and looked closer at my 70 CJ5 V6 chassis and lo and behold there it was.