Page 1 of 1
I'm going to fabricate some stuff
Posted: Sun Jan 06, 2013 12:51 pm
by Deadguy
and if anyone has them, I need dimensions!
I'm going to make the winch mount for a military Ramsey 50 PTO. Just the front part that sits on the bumper! I'm also going to make the PTO "lock lever" that holds the winch lever in place. I know Wes already posted something with the dimensions for the frame, but I can't find them!
Posted: Sun Jan 06, 2013 1:56 pm
by Bill_F
I believe Joe from Vintage Wiring of Maine has reproduction of the lock for the pto already
Posted: Sun Jan 06, 2013 2:05 pm
by wesk
Go to my photo gallery:
http://www.willysmjeeps.com/v2/modules. ... _album.php
Go to 2nd page.
Click on the "Winch" album
Click on the Album "Ramsey 50/50R Winch System
Then copy the drawings for the brackets
Then click on the album "Ramsey 105 PTO" and copy the illustrations there.
Posted: Sun Jan 06, 2013 6:03 pm
by Deadguy
Thanks Wes! I shot Joe from Vintage wiring an email.
Fabrication
Posted: Tue Jan 08, 2013 9:42 am
by flightmap
Would you be interested in fabricating a hanger bearing and shaft for the winch? Would buy one if reasonable
Ken
Posted: Tue Jan 08, 2013 10:47 am
by ECVJeeps
The front section of the frame is 2" x 2" x 1/4" "T" stock, that is the hard part to find. The rest is just standard stock.
Posted: Wed Jan 09, 2013 6:57 pm
by Deadguy
yes, flightmap, I would definitely buy one if reasonable. Shoot me an email at dan@danhenk.com!